News

No More Pulling Paint Off the Registers or Walls!

Posted by Corey Breed on

Believe it or not, but your job performing duct leakage tests is dangerous. When you’re relying on vent tape, you run the risk of falling off a ladder and easily damaging your customer’s home. Ditching the tape and starting to use Vent Caps will solve both problems. You’ll be able to lose the ladder and do a better job of protecting the property you’re testing. How Vent Caps Work Unlike vent tape which has an adhesive that sticks to the register and surrounding area, a Vent Cap simply locks into place over the register with non-damaging foam and adequate pressure....

Read more →

Meet Industry Standards with Vent Caps

Posted by Corey Breed on

Conducting duct leakage tests requires a tight seal on every register. Previously this was only possible with vent tape, but now there’s a better solution — one that’s been approved by BPI: Vent Caps. Building Performance Institute Seal of Approval For over 20 years, contractors have trusted the Building Performance Institute to set the highest industry standards for energy efficiency diagnostics and installations. In order to help contractors get the best results and enforce industry regulations, the BPI Product Listing Program now identifies the products, tools, and materials that are the most effective. The rigorous quality assurance process ensures only...

Read more →

[INFOGRAPHIC] How To Use Vent Cap Systems

Posted by Corey Breed on

Read more →

Lose the Ladder By Switching to Vent Cap Systems

Posted by Corey Breed on

Duct leakage tests and energy audits require a lot of equipment, right? But what if you could eliminate the ladder and the vent tape with one solution? It’s now possible with the simplicity of Vent Caps! The Dangers of Duct Leakage Testing Setting up for a duct leakage test requires positioning a ladder under every register, climbing up, and wrestling with the tape needed to seal it. Now think about it — how many times did you knock the ladder into something at a customer’s home? Did you ever place it slightly off-kilter and take a spill? How long does...

Read more →

Your Duct Leakage Testing Could Take Less Time!

Posted by Corey Breed on

As an energy auditor or HVAC professional, you know just how time-consuming taping up each duct vent can be during a leakage test. What if there was an easier way that would allow you to spend less time taping, so you can go about your day more quickly and easily? Vent Cap Systems Save Time Compared with traditional vent tape where you have to climb up on a ladder and deal with a sticky mess each and every time, Vent Cap Systems allows you to spend less than 30 seconds sealing and unsealing a vent. That’s only half a minute...

Read more →